“solar energy technologies +solar energy pros and cons video”

Different sources of energy produce different amounts of heat-trapping gases. As shown in this chart, renewable energies tend to have much lower emissions than other sources, such as natural gas or coal.

Jump up ^ Mearian, Lucas. U.S. flips switch on massive solar power array that also stores electricity: The array is first large U.S. solar plant with a thermal energy storage system, 10 October 2013. Retrieved 18 October 2013.

The DOE and other federal government agencies, fund research and development of renewable energy technologies. Most of the research and development is carried out at the National Labs and in cooperation with academic institutions and private companies. The availability of these programs depends on annual appropriations from the United States Congress.

While a relatively small fraction of our overall energy supply in 2012 (the most recent data from the Energy Information Administration), the United States was the world’s largest consumer of renewable energy from geothermal, solar, wood, wind, and waste for electric power generation producing 22% of the world’s total. In 2015, the distribution of U.S. renewable consumption by source was [iii]:

WASHINGTON, D.C. – Today, the Solar Energy Industries Association (SEIA) urged the New Jersey Legislature to pass Senate Bill 877 to keep the state’s solar industry growing and maintain the more than 7,100 solar jobs in one of the largest solar markets in the U.S.  

While many renewable energy projects are large-scale, renewable technologies are also suited to rural and remote areas and developing countries, where energy is often crucial in human development.[12] Former United Nations Secretary-General Ban Ki-moon has said that renewable energy has the ability to lift the poorest nations to new levels of prosperity.[13] As most of renewables provide electricity, renewable energy deployment is often applied in conjunction with further electrification, which has several benefits: Electricity can be converted to heat (where necessary generating higher temperatures than fossil fuels), can be converted into mechanical energy with high efficiency and is clean at the point of consumption.[14][15] In addition to that electrification with renewable energy is much more efficient and therefore leads to a significant reduction in primary energy requirements, because most renewables don’t have a steam cycle with high losses (fossil power plants usually have losses of 40 to 65%).[16]

In 2010, Helgesen won a Skoll Scholarship to Oxford, for M.B.A. students seeking “entrepreneurial solutions for urgent social and environmental challenges,” and spent the year researching the renewables market. He found two like-minded business partners, and, in 2012, they set up shop in Arusha. At first, they planned to build solar microgrids to power cell-phone towers and sell the excess electricity to locals, but, Helgesen said, “it became clear that that was a pretty expensive way to go.” So they visited customers in their homes to ask them what they wanted. “Those conversations were the smartest thing we ever did,” Helgesen said. “I remember this one customer, she had a baby, and she would keep the kerosene lamp on low all night, as a night-light. It was costing thirty dollars a month in kerosene. And I was, like, Wow, for thirty dollars a month I could do a lot better.”

Burlington, Vermont, was the only US city reporting to CDP that sourced all of its power from renewable sources after having fully transitioned in 2015. Research from the Sierra Club states there are five such cities in the US in total.

Consumers in nearly every state can purchase green power, which represents electricity generated from specific types of renewable energy resources. Most of these voluntary programs generally involve the physical or contractual delivery of the electricity generation resource to the customer or utility.

Fly over the Carrizo Plain in California’s Central Valley near San Luis Obispo and you’ll see that what was once barren land is now a sprawling solar farm, with panels covering more than seven square miles — one of the world’s largest clean-energy projects. When the sun shines over the Topaz Solar Farm, the shimmering panels produce enough electricity to power all of the residential homes in a city the size of Long Beach, population 475,000.

Nominal voltage [12]refers to the voltage of the battery that the module is best suited to charge; this is a leftover term from the days when solar modules were only used to charge batteries. The actual voltage output of the module changes as lighting, temperature and load conditions change, so there is never one specific voltage at which the module operates. Nominal voltage allows users, at a glance, to make sure the module is compatible with a given system.

National Electrical Code (NEC) The NEC is a regionally adoptable standard for the safe installation of electrical wiring and equipment in the United States. It is part of the National Fire Codes series published by the National Fire Protection Association (NFPA), a private trade association.Despite the use of the term “national”, it is not a federal law. It is typically adopted by states and municipalities in an effort to standardize their enforcement of safe electrical practices. In some cases, the NEC is amended, altered and may even be rejected in lieu of regional regulations as voted on by local governing bodies. The 1984 and later editions of the NEC contain Article 690, “Solar Photovoltaic Systems” which provide standards for installing a solar PV system.

The best way of lowering the cost of solar energy is to improve the cell’s efficiency, according to Larry Kazmerski, Director of the DOE’s National Center for Photovoltaics. “As the scientists and researchers at the NCPV push the envelope of solar-cell efficiency, we can begin to visualize the day when energy from the sun will be generating a significant portion of the country’s electric power demand.” Any improvements and subsequent cost cuts will also be vital to space applications.Also try finding the right Electric company in order to save money. Power companies can help you benefit with decisions such as this.

From the end of 2004, worldwide renewable energy capacity grew at rates of 10–60% annually for many technologies. In 2015 global investment in renewables rose 5% to $285.9 billion, breaking the previous record of $278.5 billion in 2011. 2015 was also the first year that saw renewables, excluding large hydro, account for the majority of all new power capacity (134 GW, making up 53.6% of the total). Of the renewables total, wind accounted for 72 GW and solar photovoltaics 56 GW; both record-breaking numbers and sharply up from 2014 figures (49 GW and 45 GW respectively). In financial terms, solar made up 56% of total new investment and wind accounted for 38%.

Conventional hydroelectricity works very well in conjunction with solar power, water can be held back or released from a reservoir behind a dam as required. Where a suitable river is not available, pumped-storage hydroelectricity uses solar power to pump water to a high reservoir on sunny days then the energy is recovered at night and in bad weather by releasing water via a hydroelectric plant to a low reservoir where the cycle can begin again.[89] However, this cycle can lose 20% of the energy to round trip inefficiencies, this plus the construction costs add to the expense of implementing high levels of solar power.

The market for renewable energy technologies has continued to grow. Climate change concerns and https://www.youtube.com/edit?o=U&video_id=qOap1A9um3E in green jobs, coupled with high oil prices, peak oil, oil wars, oil spills, promotion of electric vehicles and renewable electricity, nuclear disasters and increasing government support, are driving increasing renewable energy legislation, incentives and commercialization.[9] New government spending, regulation and policies helped the industry weather the 2009 economic crisis better than many other sectors.[23][195]

There are about as many people living without electricity today as there were when Thomas Edison lit his first light bulb. More than half are in sub-Saharan Africa. Europe and the Americas are almost fully electrified, and Asia is quickly catching up, but the absolute number of Africans without power remains steady. A World Bank report, released in May, predicted that, given current trends, there could still be half a billion people in sub-Saharan Africa without power by 2040. Even those with electricity can’t rely on it: the report noted that in Tanzania power outages were so common in 2013 that they cost businesses fifteen per cent of their annual sales. Ghanaians call their flickering power dum/sor, or “off/on.” Vivian Tsadzi, a businesswoman who lives not far from the Akosombo Dam, which provides about a third of the nation’s power, said that most of the time “it’s dum dum dum dum.” The dam’s head of hydropower generation, Kwesi Amoako, who retired last year, told me that he is proud of the structure, which created the world’s largest man-made lake. But there isn’t an easy way to increase the country’s hydropower capacity, and drought, caused by climate change, has made the system inconsistent, meaning that Ghana will have to look elsewhere for electricity. “I’ve always had the feeling that one of the main thrusts should be domestic solar,” Amoako said. “And I think we should put the off-grid stuff first, because the consumer wants it so badly.”

Jump up ^ Schröder, K.-P.; Smith, R.C. (2008). “Distant future of the Sun and Earth revisited”. Monthly Notices of the Royal Astronomical Society. 386 (1): 155–163. arXiv:0801.4031 . Bibcode:2008MNRAS.386..155S. doi:10.1111/j.1365-2966.2008.13022.x. See also Palmer, J. (2008). “Hope dims that Earth will survive Sun’s death”. New Scientist. Retrieved 24 March 2008.

Solar cells have many applications. They have long been used in situations where electrical power from the grid is unavailable, such as in remote area power systems, Earth-orbiting satellites and space probes, consumer systems, e.g. handheld calculators or wrist watches, remote radiotelephones and water pumping applications. A large no. of solar cells are combined in an arrangement called solar cell panel that can deliver enough electricity for practical use.

The International Organization for Standardization has established several standards relating to solar energy equipment. For example, ISO 9050 relates to glass in building while ISO 10217 relates to the materials used in solar water heaters.

In 1954, scientists at Bell Telephone discovered that silicon (an element found in sand) created an electric charge when it was exposed to lots of sunlight. Just a few years later, silicon chips were used to help power space satellites.

Solar energy, radiant light and heat from the sun, is harnessed using a range of ever-evolving technologies such as solar heating, photovoltaics, concentrated solar power (CSP), concentrator photovoltaics (CPV), solar architecture and artificial photosynthesis.[48][49] Solar technologies are broadly characterized as either passive solar or active solar depending on the way they capture, convert and distribute solar energy. Passive solar techniques include orienting a building to the Sun, selecting materials with favorable thermal mass or light dispersing properties, and designing spaces that naturally circulate air. Active solar technologies encompass solar thermal energy, using solar collectors for heating, and solar power, converting sunlight into electricity either directly using photovoltaics (PV), or indirectly using concentrated solar power (CSP).

Geothermal energy comes from heat produced naturally inside the Earth. Geothermal reservoirs are underground areas of steam or hot water that can be used to produce electricity or heat for our needs. Geothermal pumps can be used to move heat from the Earth into homes during the winter and move heat from homes back to the Earth during the summer. This works because the temperature just beneath the Earth’s surface remains fairly constant throughout the year, and it is hotter than the air in winter but cooler than the air in summer.

Renewable energy (sources) or RES capture their energy from existing flows of energy, from on-going natural processes, such as sunshine, wind, flowing water, biological processes, and geothermal heat flows.

Comments

  1. Molly

    There were 90,000 wind operations jobs in the United States in 2015. The wind industry in the United States generates tens of thousands of jobs and billions of dollars of economic activity.[31] Wind projects boost local tax bases, and revitalize the economy of rural communities by providing a steady income stream to farmers with wind turbines on their land.[28] GE Energy is the largest domestic wind turbine manufacturer.[28]
    Based on REN21’s 2016 report, renewables contributed 19.2% to humans’ global energy consumption and 23.7% to their generation of electricity in 2014 and 2015, respectively. This energy consumption is divided as 8.9% coming from traditional biomass, 4.2% as heat energy (modern biomass, geothermal and solar heat), 3.9% hydro electricity and 2.2% is electricity from wind, solar, geothermal, and biomass. Worldwide investments in renewable technologies amounted to more than US$286 billion in 2015, with countries like China and the United States heavily investing in wind, hydro, solar and biofuels.[4] Globally, there are an estimated 7.7 million jobs associated with the renewable energy industries, with solar photovoltaics being the largest renewable employer.[5] As of 2015 worldwide, more than half of all new electricity capacity installed was renewable.[6]
    Not all renewable energy resources come from the sun. Geothermal energy taps the Earth’s internal heat for a variety of uses, including electric power production, and the heating and cooling of buildings. And the energy of the ocean’s tides come from the gravitational pull of the moon and the sun upon the Earth.

Leave a Reply

Your email address will not be published. Required fields are marked *